Owner`s manual

23
Adjusting your Organ
Settings for Each Individual
Part
The settings in the following table can be set separately for
each part.
Procedure
1. Hold down [VOLUME] and press [VALUE] to
enter Edit mode.
The “EDIT” MODE indicator lights.
2. Turn [TONE CATEGORY] to select the
parameter.
3. Turn [VALUE] to adjust the setting.
4. Press [VOLUME] to exit Edit mode.
Description of Each Parameter
■ EQ ON/OFF
This setting determines whether or not the EQ in each part is
used.
As explained in the section Adjusting Equalizer (p. 22),
adjustments to the EQ settings themselves are applied to the
MX-200 overall. The EQ ON/OFF setting selects whether the
internal EQ is used in each individual part.
■ Part Type
This selects whether a tone (ton) or rhythm set (rhy) is
assigned to the selected part. Normally, a tone is assigned.
Only rhythm sets are assigned to PART 10.
■ Part Mute
This setting determines whether sounds in each part are
muted (ON), or played (OFF).
Rodgers organs feature 12 to 16 parts that are used in
exchanging performance data. We recommend that these
parts be muted to prevent their sounds from being played.
■ Part Level
These settings determine the volume level of each part.
They are used primarily to achieve a volume balance among
the different parts.
■ Part Pan
These settings set the apparent position of the sound in each
part.
A setting of L64 places the sound to the far left, 0 positions
the sound at the center, and 63r puts the sound at the far
right.
■ Part Coarse Tune
This sets the pitch of each part to a maximum four octaves up
or down in semitone units.
This is indicated by the values -48 to 48.
■ Part Fine Tune
This sets the pitch of each part to a maximum half-semitone
up or down in units of one cent (1/100th of a semitone).
■ Part Reverb Send Level
This sets the amount of reverb applied in each part. Set this
to 0 for parts to which you do not want reverb applied. No
EQ is applied to the reverb output.
■ Part Chorus Send Level
This sets the amount of chorus applied in each part. Set this
to 0 for parts to which you do not want chorus applied. No
EQ is applied to the chorus output.
■ Part Output Level (DRY SEND)
This sets the output level of the source sound from each part.
You can apply EQ to this source sound.
TONE CATEGORY
Knob Position
Parameter Value
MIXTURE EQ ON/OFF OFF, On
REED TYPE ton, rhy
FLUE MUTE OFF, On
PIANO LEVEL 0–127
E.ORGAN PAN L64–63r
STRINGS COARSE TUNE -48–48
CHOIR FINE TUNE -50–50
BRASS REVERB SEND 0–127
CHIMES CHORUS SEND 0–127
PERC DRY SEND 0–127