Owner`s manual

21
Setting up your MX-200
Tuning the Power ON/OFF
■ Turning On the MX-200
Once the connections have been completed (pp. 18–20), turn
on power to your various devices in the order specified. By
turning on devices in the wrong order, you risk causing
malfunction and/or damage to speakers and other devices.
1. Press the MX-200’s [POWER] button to turn on
the power.
2. Turn on the power to other connected devices.
* This unit is equipped with a protection circuit. A brief interval
(a few seconds) after power up is required before the unit will
operate normally.
■ Turning Off the MX-200
1. Turn off the power to the connected devices.
2. Press the MX-200’s [POWER] button to turn off
the power.
Restoring the Factory
Settings (Factory Reset)
When using the MX-200 for the first time, reset the unit to its
original factory settings.
The following procedure resets all of the settings stored in
the MX-200 to the original factory settings.
As the result of executing the following procedure, all data
stored within the unit will revert to the original factory
condition. Do not perform this procedure after you’ve
adjusted the settings to match your organ.
1. Hold down [VOLUME] and press [VALUE] to
enter Edit mode.
The “EDIT” MODE indicator lights.
2. Turn [TONE CATEGORY] to select “CELESTE
(SETUP MODE).”
The “SETUP” MODE indicator lights.
3. Turn [PART] to select “3 (FACTORY RESET).”
“Fct” appears in the display.
4. Press [VALUE].
“Sur” flashes, and a confirmation screen is displayed.
5. Press [VALUE] once more to execute the Factory
Reset.
Once completed, the MX-200 returns to the regular MX
mode.
* To cancel the procedure, press [VOLUME].
Listening to the Demo Songs
Listen to the output of the sound to confirm that the MX-200
is properly connected.
1. Press [VOLUME] to enter Demo mode.
2. Turn [VALUE] to select the demo song you want
to hear.
3. Press [VALUE] to start the song.
4. Press [VALUE] once again to stop the song.
5. Press [VOLUME] to exit Demo mode.
This concludes the setup procedure.