Owner`s manual

17
Setting up your MX-200
Getting Ready to Play
■ Attaching the Rubber feet
Attach the rubber feet that were supplied with the MX-200,
as shown in the figure. Use the small holes on the bottom as a
guide for positioning the rubber feet when attaching them.
fig.Foot.e
■ Attaching to the Lower Part of
the Organ
1. Remove the four screws securing the side boards.
2. Place the supplied brackets between the side
boards and the instrument and secure with the
screws removed in Step 1.
fig.Mount1
3. Secure the organ with the included screws.
fig.Mount2
Two or more persons are required to perform this
installation. Be sure to use due care during the procedure. In
performing the installation, carefully note the location of the
input and output jacks, and choose a location where no
obstruction will result.
OUT
IN
MIDI
AC IN 12V 500mA
USE BOSS BRA
ADAPTOR ONLY
JV-1010
THRU
affix the supplied rubber feet
onto the bottom of the unit