User manual

ROCSECURE – Rocsafe MX User Manual
20
7 Smart Card Security Features
You can perform certain smart card related security functions with Rocsafe MX. These functions are only available
before/during authentication. The following functions are available.
7.1 PIN Change
You can change your smart card PIN with Rocsafe MX. It is recommended that you change the default factory PIN
to another one that only you know. Follow these steps to change your PIN.
1. Insert smart card into Rocsafe MX.
2. Press the Change Pin button, followed by the ‘1’ button.
3. Press Enter. The Status LED will blink three times.
4. Enter the current 8-digit PIN and press Enter. The Status LED blinks twice to notify that you may press the new
PIN.
5. Enter the new 8-digit PIN and press Enter. The Status LED blinks twice to notify that you may press the
confirmed new PIN.
6. Enter the new confirmed 8-digit PIN and press Enter.
Upon a successful PIN change, Rocsafe MX will proceed to connect the drive. At the same time, the Status LED will
blink three times and there will be two ‘beep’ sounds upon a successful PIN change. If not, the Error LED will blink
continuously.
CAUTION:
Smart Card security and administrative functions must be performed carefully as they
cause changes in smart cards and associated PINs. Please read the following instructions carefully and
follow them when performing administrative functions.
Note
:
• Rocsafe MX only accepts 8-digit PINs. If a shorter or longer PIN is entered, the Error LED will blink
continuously. Press the Esc button to restart the authentication process again. You will need to
restart the entire PIN Change process from step 2.
• Pressing the Esc key restarts the entire authentication process.
• Smart card PINs are specific to the physical smart card. Please be aware that you may have
different PINs for each of the two included smart cards.
Again, you will be locked out of your smart card after 8 incorrect PIN attempts.