User manual

ROCSECURE – Rocsafe MX User Manual

3. Installation

To use Rocsafe MX, simply remove the bottom cover and install your 2.5” SATA hard drive by connecting it to the

22pin SATA connector within. Detailed step-by-step instructions are provided in this section.

3.1 Installing a hard drive

Rocsafe MX supports standard 2.5” SATA hard drives. To install your 2.5” hard drive, follow these three easy steps:

1. Turn the Rocsafe MX enclosure over and

carefully remove its bottom cover, by pressing

the latch that can be found on the sides of the

unit.

2. Connect the 2.5” SATA hard drive firmly to the

22pin SATA connector on the tray.

3. Carefully snap the bottom cover to the top

cover.