Instruction manual

ROC/FloBoss Accessories Instruction Manual

5-15 Power Accessories Rev. Mar/10

If the battery does not have a terminal that accommodates the lug, then the temperature compensation

sensor should be mounted inside the battery box to sense battery temperature. Figure 5-9 shows an

example of this mounting method for a small ROC enclosure when the 7 Amp-hour battery is used.

 NOTE: The temperature compensation cable must be correctly installed, for proper operation

of the power supply/charger. If the cable is damaged, it must be replaced.

DOC0293B

Figure 5-9. Thermistor Cable Location in Small ROC Enclosure

5.4.6 Checking for Proper Output Voltage

The power supply/charger is adjusted at the factory for optimum output voltage when used with lead-

acid batteries. Under normal conditions, the output voltage should not require readjustment.

Be sure to follow any applicable procedures for hazardous areas. Be sure also to take

appropriate precautions for the ROC or FloBoss unit and any other equipment being

powered down during the following procedure.

Thermisto

Cable