Instruction manual

ROC/FloBoss Accessories Instruction Manual

4-3 Enclosure Accessories Rev. Feb/05

SCREW

DISPLAY

COVER ASSEMBLY

PRE-PUNCHED DOOR

(NOT INCLUDED)

CABLE

SSEMBLY

GASKET

WINDOW

HEX

NUT

LCD

SUB-ASSEMBLY

6004P.WMF

Figure 4-2. LDP Parts Orientation

2. Remove the cutout cover from the enclosure door.

3. Place two small drops of RTV sealant on the LDP sub-assembly to hold the window in place

while installing the panel. Refer to Figure 4-3.

TAB UP

RTV

LCD SUB-ASSEMBLY

WINDOW

RTV

6004A.WMF

Figure 4-3. LCD Sub-Assembly

4. Remove the protective paper from the window and place the window in the cavity.

5. Place a small bead of RTV (approximately 1/16 inch wide) onto the gasket surface. Align the

gasket holes to the door studs with the RTV facing the door and press into place. Refer to

Figure 4-4.