Manualshelf

Instruction manual

ManualsBrandsrocpower Manualselectrical equipment & supplies8
919293949596979899100
ROC/FloBoss Accessories Instruction Manual
7-2 Communications Accessories Rev. Feb/05
7.2.3 How to Install the LOI Switch
Use the following steps to install the LOI switch. Refer to Figure 7-1 through Figure 7-4.
1. Verify all specifications for the LOI switch are met. Refer to Table 7-1 on page 7-5 for
specifications on the LOI switch.
2. Ensure all power is removed from the unit.
3. Clean the mounting location using isopropyl alcohol.
4. Measure and mark the LOI switch position inside of the enclosure as shown in Figure 7-1 and
Figure 7-2.
5. Remove the backing from the adhesive pad on the back of the LOI switch.
6. Position the LOI switch over the marked area and press firmly into place.
NOTE: The switch cannot be repositioned.
7. Connect all wiring as in Figure 7-4.
8. Reconnect power to the unit.