Use and Care Manual

OSCILLATING TOOL ENG
8
SYMBOLS TECHNICAL DATA
Rated voltage 120 V~60 Hz
Amps 4.2 A
Oscillation speed 10000-19000/min
Oscillation angles 5°/3.4°
Protection class /II
Tool weight (without power cable) 4.0 lbs
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction
book carefully.
ASSEMBLY AND OPERATION
Action Figure
Changing The Work Mode
WARNING: Before changing the
work mode make sure that the
On/Off Switch is OFF.
Fast Cutting Work Mode(5
o
):
Aggressive setting for fastest cutting
or highest removal rate of material,
where smoothly finished surface is not
required.
Smooth Control Work Mode(3.4
o
):
General purpose setting for slower but
smoother and more detailed cutting,
sanding and grinding.
See Fig. A1, A2
Mounting Accessories
See Fig. B-D
Mounting The Sanding Sheet See Fig. E
Operating The On/Off Switch See Fig. F
Using The Variable Speed Dial See Fig. G
LED Light See Fig. H
To reduce the risk of injury, user must
read instruction manual
Warning
Double insulation
Wear ear protection
Wear eye protection
Wear dust mask
Wear protective gloves
Avoid danger of injury from the sharp
edges of the accessories.
Accessories can become very hot while
working, presenting danger of burns!
Make sure the tool is unplugged prior to
changing accessories.
Before working with your tool make sure
that no power cords will be damaged.
High oscillation frequency.
Low oscillation frequency.
Incorrect
Correct