Use and Care Manual

3.0A OSCILLATING TOOL ENG
8
SYMBOLS TECHNICAL DATA
Rated voltage 120 V~60 Hz
Amps 3.0 A
Oscillations speed 11000-21000/min
Oscillations angle 3.2°
Protection class /II
Tool weight (without power cable) 2.9 lbs
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction
book carefully.
Assembly and Operation
Action Figure
Mounting Accessories See Fig. A-C
Mounting the Sanding Sheet See Fig. D
Operating the On/Off Switch See Fig. E
Using the Variable Speed Dial See Fig. F
The Variable Speed Dial can be used to set the optimum
oscillating frequency according to the accessories used
and the respective application.
Oscillation
frequency
Application
High oscillation
frequency:
Sanding, Sawing, Rasping
and Polishing Stone and
Metal.
Low oscillation
frequency:
Scraping, Polishing Varnishes.
WARNING-To reduce the risk of injury,
user must read instruction manual
Double insulation
Warning
Wear ear protection
Wear eye protection
Wear dust mask
Wear protective gloves
Make sure the tool is unplugged prior
to changing accessories.
Before working with your tool make
sure that no power cords will be
damaged.
Avoid danger of injury from the sharp
edges of the accessories.
Accessories can become very hot
while working, presenting danger of
burns!
High oscillation frequency
Low oscillation frequency