User`s manual

AT Command Reference Manual
3-52 1048
(0,1,2),(0,1)
-SMC= x - Enable/Disable ML144 Data Burst
0 = Disable data burst
1 = Enable data burst (Default)
ML144 data burst can be enabled using the -SMC command in ML144 modulation. Data burst will keep the audio channel
open only when energy is detected on the handset or headset. When silence is detected in data burst mode, the connected
modems will upshift in speed for higher throughput. Disabling data burst mode will keep the audio channel open at all times
during the AudioSpan connection.
Reporting Selected Options
The modem reports the selected options in response to the following command:
-SMC?
The response is:
<x>
Example:
-SMC?
1
Reporting Supported Options
The modem reports the supported options in response to the following command:
-SMC=?
The response is:
(list of<x> values)
Example:
-SMC=?
(0,1)