User`s manual

AT Command Reference Manual
1048 3-35
*NCn - Country Select
Up to four sets of country parameters may be stored in the EPROM. This command checks to see if the entered number
matches the country code of one of the countries stored in the EPROM. If found, the modem stores the location of that
country in NVRAM. Upon power up or a soft reset (Z command), the modem uses this location to load the parameters for
the corresponding country. The default value of zero is used if no NVRAM is installed or the NVRAM failed self test during
reset.
Note:
Automatic DAA country code recognition is enabled by the *NC0 command (the 0 country code is reserved for this
function). Automatic DAA country code recognition is disabled by the *NCn command selecting any other valid country code.
*NCn Select country parameters corresponding to entered country code (n). The country codes are:
Country Code (n)
Australia 40
Austria 1
Belgium 2
Bulgaria 27
Canada 20
China 41
Czech Republic 19
Denmark 3
Finland 4
France 5
Germany 6
Greece 17
Hong Kong 42
Hungary 23
India 30
Ireland 7
Israel 18
Italy 8
Japan 43
Korea 44
Luxembourg 9
Mexico 21
Netherlands 10
New Zealand 48
Norway 11
Philippines 43
Poland 24
Portugal 12
Russia 25
Singapore 47
Slovac Republic 26
Spain 13
Sweden 14
Switzerland 15
Taiwan 46
United Kingdom 16
United States 22
Result Codes:
OK If parameters corresponding to entered country code are present in EPROM.
ERROR Otherwise.