User`s manual

AT Command Reference Manual
1048 3-33
-SEC=n - Enable/Disable MNP10-EC
Enables or disables MNP10-EC operation. The command format is:
-SEC=n,[<tx level>] where <tx level> is the optional transmit level sub parameter.
-SEC=0 Disable MNP10-EC; the transmit level is that defined in S91.
-SEC=1,[<tx level>] Enable MNP10-EC; the transmit level will be defined by the sub parameter <tx level>
range 0 to 30 (0 dBm to -30 dBm), the default <tx level> (<tx level> not specified) is the
S91 value.
Result Codes:
OK n=0, 1, or 1 and <tx level>=0 to 30
ERROR Otherwise
Example: AT-SEC=1,18 enables MNP10-EC and sets the transmit level to -18 dBm.
Note:
If AT-SEC=0, the modem will automatically set AT-SEC=1 if the remote modem indicates Cellular in the V.8 bis/V.8
phase or if a Cellular Driver is loaded and the Cell Phone is attached.
Inquiries
AT-SEC? Retrieves the current -SEC command settings, e.g., 1,18.
@Mn - Initial Cellular Power Level Setting
This command is included only for compatibility and performs no function.
@M0 @M0 command.
.
.
.
@M30 @M30 command.
Result Codes:
OK n = 0 to 30.
ERROR Otherwise.
:E - Compromise Equalizer Enable Command
This command is included only for compatibility and performs no function.
:E0 :E0 command.
:E1 :E1 command.
Result Codes:
OK n = 0 or 1.
ERROR Otherwise.