User`s manual

AT Command Reference Manual
1048 7-27
Recording a Handset Conversation on the Phone Line
To recording a handset conversation on the phone line, issue:
AT#VLS=8 (valid after Voice On-line mode)
This command engages the Caller ID relay to allow recording of conversation when using a handset by routing the signal to
the audio codec (if populated).
To deactivate the Caller ID relay, the host should issue an AT#VLS=0 or AT#VLS=6 to return to phone line or speakerphone
mode, respectively.
Recording/Playback from Handset through Sound Chip
To recording/playback from the handset through a sound chip (valid after voice on-line mode), issue:
AT#VLS=9
This command routes the handset to the sound codec to allow recording/playback of audio (e.g. greeting messages) through
the local handset.
#SPK Parameter
The setting of the speakerphone can be changed with the AT#SPK command:
AT#SPK=<mute>,<spkr>,<mic>
The #SPK command can be used to control the microphone state (mute or on), adjust the speaker volume, and microphone
gain. The #SPK parameters are are valid only after the modem has entered the Voice Online (VCON) mode while in the
#VLS=6 setting (after a VCON during originate or answer). The modem will respond "ERROR" otherwise.
Parameters (Except ACF/AFCL):
<mute> Mute Parameter Number
0 microphone mute
1 microphone on (default)
2 Room Monitor mode (mic on max AGC, speaker off)
<spkr> Speaker Output Attentuation
Range: 0 to15 (speaker attenuation in 2 dB steps)
0 0 dB attenuation
.
5 10 dB attenuation (default)
.
15 30 dB attentuation
16 Speaker mute
<mic> Microphone Gain Parameter
Range: 0 to 3
0 0 dB gain
1 6 dB gain (default)
2 9.5 dB gain
3 12 dB gain
Parameters (ACF/AFCL):
<mute> Mute Parameter Number
0 microphone mute
1 microphone on (default)
2 Room Monitor mode (mic on max AGC, speaker off)