User`s manual

AT Command Reference Manual
6-4 1048
6.1.5 Session Status Reporting
The DCE provides reports to the DTE on the status of a session. The DCE provides the following status reports:
1. Connection and hang up status:
+FCON
+FHNG:<0-255>
2. Requested DIS session parameters +FDIS: <string> reports remote facsimile capabilities.
Syntax: +FDIS: VR, BR, WD, LN, DF, EC, BF, ST
3. +FDCS: <string> reports the negotiated parameters
4. Phase C prompts:
XON, XOFF, DC2
5. Phase C base status reports: depending upon copy quality and related end-of page status:
+FPTS: <1-5>
6.1.6 Procedure Interrupt Negotiation
CCITT allows a station to request a procedure interruption at the end of a page. This request is passed between stations by
the PIP, PIN, and PRI-Q messages.
6.2 SERVICE CLASS 2 IDENTIFICATION AND SELECTION
Three commands report identification and selection information. Each of these three commands cause the DCE to send a
message to the DTE. The messages are programmable using ConfigurACE.
6.2.1 +FMFR?, Request Manufacturer Identification
The +FMFR? command causes the DCE to send a message identifying the DCE product manufacturer. The default
message is:
ROCKWELL
OK
6.2.2 +FMDL?, Identify Product Model
The +FMDL? command causes the DCE to send a message identifying the DCE product model. The default message is
similar to:
RC96XXXAC
OK
6.2.3 +FREV?, Identify Product Revision
The +FREV? command causes the DCE to send a message identifying the DCE product model revision number. The
message format is the same as the ATI3 message, e.g.:
VX.XXX-model number
OK
6.3 SERVICE CLASS 2 ACTION COMMANDS
These commands transfer data, and punctuate sessions. They also release specific T.30 messages. All action commands
must be the last command on a command line as indicated by the terminating <CR>.
All action commands initiate processes. The modem will not accept other commands from the DTE until the modem issues a
final result code (e.g., OK, CONNECT). The modem will abort the process if it receives any character before the final result
code is issued.