User`s manual

AT Command Reference Manual
1048 4-21
S95 - Extended Result Codes
The bits in this register can be set to override some of the Wn command options. A bit set to a 1 in this register will enable
the corresponding result code regardless of the Wn setting. Also, refer to Table 3-1.
Default: 0
Bit 0 CONNECT result code indicates DCE speed instead of DTE speed.
Bit 1 Append/ARQ to CONNECT XXXX result code in error-correction mode (XXXX = rate; see Table
3-1).
Bit 2 Enable CARRIER XXXX result code (XXXX = rate; see Table 3-1.
Bit 3 Enable PROTOCOL XXXX result code (XXXX = protocol identifier; see Table 3-1).
Bit 4 Reserved.
Bit 5 Enable COMPRESSION result code (XXXX = compression type; see Table 3-1).
Bit 6 Reserved.
Bit 7 Reserved.