Manualshelf

User`s manual

ManualsBrandsRockwell ManualsComputer equipmentRC56LD
81828384858687888990
Command Reference Manual
1199 3-61
Table 3-13. S-Parameter Summary
Register Function Range Units Saved Default**
S0 Rings to Auto-Answer 0-255 rings * 0
S1 Ring Counter 0-255 rings 0
S2 Escape Character 0-255 ASCII * 43
S3 Carriage Return Character 0-127 ASCII 13
S4 Line Feed Character 0-127 ASCII 10
S5 Backspace Character 0-255 ASCII 8
S6 Wait Time before Blind Dialing or for Dial Tone 2-255 s * 2
S7 Wait Time for Carrier, Silence, or Dial Tone 1-255 s * 50
S8 Pause Time for Dial Delay Modifier 0-255 s * 2
S9 Carrier Detect Response Time 1-255 0.1 s * 6
S10 Lost Carrier To Hang Up Delay 1-255 0.1 s * 14
S11 DTMF Tone Duration 50-255 0.001 s * 95
S12 Escape Prompt Delay (EPD) 0-255 0.02 s * 50
S14 General Bit Mapped Options Status - - 138 (8Ah)
S16 Test Mode Bit Mapped Options Status - - 0
S19 Reserved - - 0
S20 Reserved - - 0
S21 V.24/General Bit Mapped Options Status - - 52 (34h)
S22 Speaker/Results Bit Mapped Options Status - - 117 (75h)
S23 General Bit Mapped Options Status - 62 (3Dh)
S24 Sleep Inactivity Timer 0-255 s 0
S25 Delay to DTR Off 0-255 s or 0.01 s 5
S26 RTS-to-CTS Delay 0-255 0.01 s 1
S27 General Bit Mapped Options Status - - 73 (49h)
S28 General Bit-Mapped Options Status - - 0
S29 Flash Dial Modifier Time 0-255 10 ms 70
S30 Disconnect Inactivity Timer 0-255 10 s 0
S31 General Bit-Mapped Options Status - - 192 (C0h)
S36 LAPM Failure Control - - * 7
S38 Delay Before Forced Hangup 0-255 s 20
S39 Flow Control Bit Mapped Options Status - - 3
S40 General Bit-Mapped Options Status - - * 104 (68h)
S41 General Bit-Mapped Options Status - - * 195 (C3h)
S46 Data Compression Control - - * 138
S48 V.42 Negotiation Control - - 7
S86 Call Failure Indication 0-26 - 0
S91 PSTN Transmit Attenuation Level 0-15 dBm 10 (Country dependent)
S92 Fax Transmit Attenuation Level 0-15 dBm 10 (Country dependent)
S95 Extended Result Codes Control - - * 0
S210 V.34 Symbol Rate 0-255 - 13 (0Dh)
* Register value may be stored in one of two user profiles with the &W command.
** Default values may be modified using ConfigurACE.