User guide

6
D6 = ON Analog Mode - CDS-9022A is in analog mode.
(*) Command is only used for testing Outbound calls from the CDS-9022A
Refer to CDS-902X User Guide Configuration Menu section regarding DTE speed
for clarification.
MNP 10EC Command Set
Note: These extended commands are for CDS-9022A setup only. Refer to the section
concerning programming the analog modem profile in the CDS-902X User Guide.
AT)Mn Automatic Level Adjustment Controls
This command is included only for compatibility and performs no function.
AT)M0 AT)M0 command.
AT)M1 AT)M1 command.
AT)M2 AT)M2 command.
AT*Hn Link Negotiation Speed
This command is included only for compatibility and performs no function.
*H0 *H0 command.
*H1 *H1 command.
*H2 *H2 command.
AT-Kn MNP Extend Services
Enables or disables conversion of a V.42 LAPM connection to an MNP 10
connection. The parameter value, if valid, is written to S40 bits 0 and 1.
AT-K0 Disables V.42 LAPM to MNP 10 conversion. (Default.)
AT-K1 Enables V.42 LAPM to MNP 10 conversion.
AT-K2 Enables V.42 LAPM to MNP 10 conversion; inhibits MNP Extended
Services initiation during V.42 LAPM answer mode detection phase.
AT-Qn Enable Fallback to V.22bis/V.22
This command is included only for compatibility and performs no function.
AT-Q0 AT-Q0 command.
AT-Q1 AT-Q1 command.
AT@Mn Initial Cellular Power Level Setting
This command is included only for compatibility and performs no function.
@M0 @M0 command.
.
.
.
@M30 @M30 command.