Specifications

UC864-E/G AT Commands Reference Guide
80304ST10041a Rev. 3 - 18/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 9 of 259
3.1 Definitions
The following syntactical definitions apply:
<CR> Carriage return character, is the command line and result code terminator character, which
value, in decimal ASCII between 0 and 255,is specified within parameter S3. The default value
is 13.
<LF> Linefeed character, is the character recognised as line feed character. Its value, in decimal
ASCII between 0 and 255, is specified within parameter S4. The default value is 10. The line
feed character is output after carriage return character if verbose result codes are used (V1
option used ) otherwise, if numeric format result codes are used (V0 option used) it will not
appear in the result codes.
<...> Name enclosed in angle brackets is a syntactical element. They do not appear in the command
line.
[...] Optional subparameter of a command or an optional part of TA information response is
enclosed in square brackets. Brackets themselves do not appear in the command line. When
subparameter is not given in AT commands which have a Read command, new value equals
to its previous value. In AT commands which do not store the values of any of their
subparameters, and so have not a Read command, which are called action type commands,
action should be done on the basis of the recommended default setting of the subparameter.