Specifications

UC864-E/G AT Commands Reference Guide
80304ST10041a Rev. 3 - 18/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 86 of 259
+CPIN - Enter PIN
To check the status of the PIN request use the command AT+CPIN?
Note: If all parameters are omitted then the behaviour of Set command is
the same as Read command.
AT+CPIN? Read command reports the PIN/PUK/PUK2 request status of the device in
the form:
+CPIN: <code>
where:
<code> - PIN/PUK/PUK2 request status code
READY - ME is not pending for any password
SIM PIN - ME is waiting SIM PIN to be given
SIM PUK - ME is waiting SIM PUK to be given
PH-SIM PIN - ME is waiting phone-to-SIM card password to be given
PH-FSIM PIN - ME is waiting phone-to-very first SIM card password to be
given
PH-FSIM PUK - ME is waiting phone-to-very first SIM card unblocking
password to be given
SIM PIN2 - ME is waiting SIM PIN2 to be given; this <code> is returned
only when the last executed command resulted in PIN2
authentication failure (i.e. +CME ERROR: 17)
SIM PUK2 - ME is waiting SIM PUK2 to be given; this <code> is returned
only when the last executed command resulted in PUK2
authentication failure (i.e. +CME ERROR: 18)
PH-NET PIN - ME is waiting network personalization password to be given
PH-NET PUK - ME is waiting network personalization unblocking
password to be given
PH-NETSUB PIN - ME is waiting network subset personalization password
to be given
PH-NETSUB PUK - ME is waiting network subset personalization
unblocking password to be given
PH-SP PIN - ME is waiting service provider personalization password to
be given
PH-SP PUK - ME is waiting service provider personalization unblocking
password to be given
PH-CORP PIN - ME is waiting corporate personalization password to be
given
PH-CORP PUK - ME is waiting corporate personalization unblocking
password to be given
Note: Pin pending status at startup depends on PIN facility setting, to
change or query the default power up setting use the command
AT+CLCK=SC,<mode>,<pin>
Example
AT+CMEE=1
OK
AT+CPIN?
+CME ERROR: 10 error: you have to insert the SIM
AT+CPIN?