Specifications

UC864-E/G AT Commands Reference Guide

80304ST10041a Rev. 3 - 18/07/08

3.5.4.4 Mobile Equipment Control

3.5.4.4.1 Phone Activity Status - +CPAS

+CPAS - Phone Activity Status

AT+CPAS Execution command reports the device status in the form:

+CPAS: <pas>

Where:

<pas> - phone activity status

0 - ready (device allows commands from TA/TE)

1 - unavailable (device does not allow commands from TA/TE)

2 - unknown (device is not guaranteed to respond to instructions)

3 - ringing (device is ready for commands from TA/TE, but the ringer is

active)

4 - call in progress (device is ready for commands from TA/TE, but a call is

in progress)

AT+CPAS=? Test command reports the supported range of values for <pas>.

Note: although +CPAS is an execution command, 3gpp TS 27.007 requires

the Test command to be defined.

Example

ATD03282131321;

AT+CPAS

+CPAS: 4 the called phone has answered to your call

ATH

Reference 3GPP TS 27.007

3.5.4.4.2 Set Phone Functionality - +CFUN

+CFUN - Set Phone Functionality

AT+CFUN=

[<fun>[,<rst>]]

Set command selects the level of functionality in the ME.

Parameters:

<fun> - is the power saving function mode

0 - minimum functionality, NON-CYCLIC SLEEP mode: in this mode, the

AT interface is not accessible. Consequently, once you have set <fun>

level 0, do not send further characters. Otherwise these characters

remain in the input buffer and may delay the output of an unsolicited

result code. The first wake-up event stops power saving and takes the

ME back to full functionality level <fun>=1.

1 - mobile full functionality with power saving disabled (factory default)

2 - disable TX