Specifications

UC864-E/G AT Commands Reference Guide

80304ST10041a Rev. 3 - 18/07/08

+CSSN - SS Notification

0 - disable

1 - enable

When <n>=1 and a supplementary service notification is received after a

mobile originated call setup, an unsolicited code:

+CSSI: <code1>

is sent to TE before any other MO call setup result codes, where:

<code1>:

0 - unconditional call forwarding is active

1 - some of the conditional call forwardings are active

2 - call has been forwarded

3 - call is waiting

5 - outgoing calls are barred

6 - incoming calls are barred

When <m>=1 and a supplementary service notification is received during a

mobile terminated call setup or during a call, an unsolicited result code:

+CSSU: <code2>

is sent to TE, where:

<code2>:

0 - this is a forwarded call (MT call setup)

2 - call has been put on hold (during a voice call)

3 - call has been retrieved (during a voice call).

4 - multiparty call entered (during a voice call)

5 - call on hold has been released (this is not a SS notification) (during a

voice call)

AT+CSSN? Read command reports the current value of the parameters.

AT+CSSN=? Test command reports the supported range of values for parameters <n>,

<m>.

Reference 3GPP TS 27.007

3.5.4.3.17 Closed User Group Supplementary Service Control -

+CCUG

+CCUG - Closed User Group Supplementary Service Control

AT+CCUG=

[<n>[,<index>

[,<info>]]]

Set command allows control of the Closed User Group supplementary

service [3GPP TS 02.85/22.085].

Parameters:

<n>

0 - disable CUG temporary mode (factory default).

1 - enable CUG temporary mode: it enables to control the CUG information

on the air interface as a default adjustment for all following outgoing