Specifications

UC864-E/G AT Commands Reference Guide

80304ST10041a Rev. 3 - 18/07/08

+CCFC - Call Forwarding Number And Condition

<class> - sum of integers each representing a class of information which

the command refers to; default 7 (voice + data + fax)

1 - voice (telephony)

2 - data

4 - fax (facsimile services)

8 - short message service

16 - data circuit sync

32 - data circuit async

64 - dedicated packet access

128 - dedicated PAD access

<time> - time in seconds to wait before call is forwarded; it is valid only

when <reason> "no reply" is enabled (<cmd>=1) or queried

(<cmd>=2)

1..30 - automatically rounded to a multiple of 5 seconds (default is 20)

Note: when <cmd>=2 and command successful, it returns:

+CCFC: <status>,<class1>[,<number>,<type>[,,,<time>]][<CR><LF>

+CCFC: <status>,<class2>[,<number>,<type>[,,,<time>]][ … ]]

where:

<status> - current status of the network service

0 - not active

1 - active

<time> - it is returned only when <reason>=2 (“no reply”) and <cmd>=2.

The other parameters are as seen before.

AT+CCFC=? Test command reports supported values for the parameter <reason>.

Reference 3GPP TS 27.007

Note When querying the status of a network service (<cmd>=2) the response line

for 'not active' case (<status>=0) should be returned only if service is not

active for any <class>.

3.5.4.3.11 Call Waiting - +CCWA

+CCWA - Call Waiting

AT+CCWA=

[<n>[,<cmd>

[,<class>]]]

Set command allows the control of the call waiting supplementary service.

Activation, deactivation, and status query are supported.

Parameters:

<n> - enables/disables the presentation of an unsolicited result code:

0 - disable

1 - enable

<cmd> - enables/disables or queries the service at network level:

0 - disable