Specifications

UC864-E/G AT Commands Reference Guide

80304ST10041a Rev. 3 - 18/07/08

3.5.4.3.8 Calling Line Identification Restriction - +CLIR

+CLIR - Calling Line Identification Restriction

AT+CLIR=[<n>] Set command overrides the CLIR subscription when temporary mode is

provisioned as a default adjustment for all following outgoing calls. This

adjustment can be revoked by using the opposite command. This command

refers to CLIR-service (3GPP TS 02.81/21.081) that allows a calling

subscriber to enable or disable the presentation of the CLI to the called

party when originating a call.

Parameter:

<n> - facility status on the Mobile

0 - CLIR facility according to CLIR service network status

1 - CLIR facility active (CLI not sent)

2 - CLIR facility not active (CLI sent)

AT+CLIR? Read command gives the default adjustment for all outgoing calls (<n>) and

also triggers an interrogation of the provision status of the CLIR service

(<m>), where

<n> - facility status on the Mobile

0 - CLIR facility according to CLIR service network status

1 - CLIR facility active (CLI not sent)

2 - CLIR facility not active (CLI sent)

<m> - facility status on the Network

0 - CLIR service not provisioned

1 - CLIR service provisioned permanently

2 - unknown (e.g. no network present, etc.)

3 - CLI temporary mode presentation restricted

4 - CLI temporary mode presentation allowed

AT+CLIR=? Test command reports the supported values of parameter <n>.

Reference 3GPP TS 27.007

Note This command sets the default behaviour of the device in outgoing calls.

3.5.4.3.9 Connected line identification presentation - COLP

+COLP - Connected line identification presentation

AT+COLP=[<n>]

Set command enables or disables the presentation of the COL at the TE

Parameter:

<n>

0 - disable

1 - enable

Note: When enabled (and called subscriber allows),

+COLP: <number>,<type>[,<subaddr>,<satype> [,<alpha>]] intermediate

result code is returned from TA to TE before any +CR or V.25ter [14]

responses. It is manufacturer specific if this response is used when normal

voice call is established.