Specifications

UC864-E/G AT Commands Reference Guide
80304ST10041a Rev. 3 - 18/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 64 of 259
3.5.4.2.7 Cellular Result Codes - +CRC
+CRC - Cellular Result Codes
AT+CRC=
[<mode>]
Set command controls whether or not the extended format of incoming call
indication is used.
Parameter:
<mode>
0 - disables extended format reporting (factory default)
1 - enables extended format reporting:
When enabled, an incoming call is indicated to the TE with unsolicited result
code
+CRING: <type>
instead of the normal RING.
where
<type> - call type:
ASYNC - asynchronous transparent data
SYNC - synchronous transparent data
REL ASYNC - asynchronous non-transparent data
REL SYNC - synchronous non-transparent data
FAX - facsimile (TS 62)
VOICE - normal voice (TS 11)
AT+CRC?
Read command returns current value of the parameter
<mode>.
AT+CRC=? Test command returns supported values of the parameter <mode>.
Reference 3GPP TS 27.007
3.5.4.2.8 Single Numbering Scheme - +CSNS
+CSNS - Single Numbering Scheme
AT+CSNS=
[<mode>]
Set command selects the bearer to be used when mobile terminated single
numbering scheme call is established. Parameter values set with +CBST
command shall be used when <mode> equals to a data service.
Parameter:
<mode>
0 - voice (factory default)
2 - fax (TS 62)
4 - data
Note: if +CBST parameter is set to a value that is not applicable to single
numbering calls, ME/TA shall map the value to the closest valid one. E.g. if
user has set <speed>=71, <name>=0 and <ce>=1 (non-trasparent