Specifications

UC864-E/G AT Commands Reference Guide

80304ST10041a Rev. 3 - 18/07/08

S7 - Connection Completion Time-Out

Reference V25ter

3.5.3.7.1 – Carrier Off With Firm Time - S10

S10 –Carrier Off With Firm Time

ATS10 Execution command has no effect and is included only for backward

compatibility with landline modems

3.5.3.7.2 Escape Prompt Delay - S12

S12 - Escape Prompt Delay

ATS12=[<time>] Set command sets:

1) the minimum period, before receipt of the first character of the three

escape character sequence, during which no other character has to

be detected in order to accept it as valid first character;

2) the maximum period allowed between receipt of first or second

character of the three escape character sequence and receipt of the

next;

3) the minimum period, after receipt of the last character of the three

escape character sequence, during which no other character has to

be detected in order to accept the escape sequence as a valid one.

Parameter:

<time> - expressed in fiftieth of a second

20..255 - factory default value is 50.

Note: the minimum period S12 has to pass after CONNECT result

code too, before a received character is accepted as valid first

character of the three escape character sequence.

ATS12? Read command returns the current value of S12 parameter.

Note: the format of the numbers in output is always 3 digits, left-filled with 0s

3.5.3.7.3 Delay To DTR Off - S25

S25 -Delay To DTR Off

ATS25=[<time>] Set command defines the amount of time, in hundredths of second, that the

device will ignore the DTR for taking the action specified by command &D.

Parameter:

<time> - expressed in hundredths of a second

0..255 - factory default value is 5.

Note: the delay is effective only if its value is greater than 5.

ATS25? Read command returns the current value of S25 parameter.