Specifications

UC864-E/G AT Commands Reference Guide

80304ST10041a Rev. 3 - 18/07/08

3.5.3.1.24 Speaker Mode - M

M - Speaker Mode

ATM<n> It has no effect and is included only for backward compatibility with landline

modems

3.5.3.2 DTE - Modem Interface Control

3.5.3.2.1 Command Echo - E

E - Command Echo

ATE[<n>]

Set command enables/disables the command echo.

Parameter:

<n>

0 - disables command echo

1 - enables command echo (factory default) , hence command sent to the

device are echoed back to the DTE before the response is given.

Note: if parameter is omitted, the command has the same behaviour of

ATE0

Reference V25ter

3.5.3.2.2 Quiet Result Codes - Q

Q - Quiet Result Codes

ATQ[<n>]

Set command enables or disables the result codes.

Parameter:

<n>

0 - enables result codes (factory default)

1 - disables result codes

2 - disables result codes (only for backward compatibility)

Note: After issuing either ATQ1 or ATQ2 every information text transmitted

in response to commands is not affected

Note: if parameter is omitted, the command has the same behaviour of

ATQ0

Example

After issuing ATQ1 or ATQ2

AT+CGACT=?

+CGACT: (0-1) nothing is appended to the response

Reference V25ter