Specifications

UC864-E/G AT Commands Reference Guide

80304ST10041a Rev. 3 - 18/07/08

+FCLASS - Select Active Service Class

0 - data

1 - fax class 1

8 - voice

AT+FCLASS? Read command returns the current configuration value of the parameter

<n>.

AT+FCLASS=? Test command returns all supported values of the parameters <n>.

Reference 3GPP TS 27.007

3.5.3.1.4 Default Reset Basic Profile Designation - &Y

&Y - Default Reset Basic Profile Designation

AT&Y[<n>] Execution command defines the basic profiles which will be loaded on

startup.

Parameter:

<n>

0..1 - profile (default is 0): the wireless module is able to store 2 complete

configurations (see &W).

Note: differently from command Z<n>, which loads just once the desired

profile, the one chosen through command &Y will be loaded on every

startup.

Note: if parameter is omitted, the command has the same behaviour as

AT&Y0

3.5.3.1.5 Default Reset Full Profile Designation - &P

&P - Default Reset Full Profile Designation

AT&P[<n>] Execution command defines which full profile will be loaded on startup.

Parameter:

<n>

0..1 – profile number: the wireless module is able to store 2 full

configurations (see command &W).

Note: differently from command Z<n>, which loads just once the desired

profile, the one chosen through command &P will be loaded on every

startup.

Note: if parameter is omitted, the command has the same behaviour as

AT&P0

Reference Telit Specifications

3.5.3.1.6 Store Current Configuration - &W

&W - Store Current Configuration