Specifications

UC864-E/G AT Commands Reference Guide

80304ST10041a Rev. 3 - 18/07/08

3.5.3 Hayes Compliant AT Commands

3.5.3.1 Generic Modem Control

3.5.3.1.1 Set To Factory-Defined Configuration - &F

&F - Set To Factory-Defined Configuration

AT&F[<value>] Execution command sets the configuration parameters to default values

specified by manufacturer; it takes in consideration hardware configuration

switches and other manufacturer-defined criteria.

Parameter:

<value>:

0 - just the factory profile base section parameters are considered.

1 - either the factory profile base section and the extended section are

considered (full factory profile).

Note: if parameter <value> is omitted, the command has the same

behaviour as AT&F0

Reference V25ter.

3.5.3.1.2 Soft Reset - Z

Z - Soft Reset

ATZ[<n>] Execution command loads the base section of the specified user profile and the

extended section of the default factory profile.

Parameter:

<n>

0..1 - user profile number

Note: any call in progress will be terminated.

Note: if parameter <n> is omitted, the command has the same behaviour as

ATZ0.

Reference V25ter.

3.5.3.1.3 Select Active Service Class - +FCLASS

+FCLASS - Select Active Service Class

AT+FCLASS=<n> Set command sets the wireless module in specified connection mode (data,

fax, voice), hence all the calls done afterwards will be data or voice.

Parameter:

<n>