Specifications

UC864-E/G AT Commands Reference Guide
80304ST10041a Rev. 3 - 18/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 30 of 259
3.5.2 General Configuration Commands
3.5.2.1.1 Select Interface Style - #SELINT
#SELINT - Select interface style
AT#SELINT=<v> Set command sets the AT command interface style depending on
parameter <v>.
Parameter:
<v> - AT command interface
2 - switches the AT command interface style of the product, to UC864-E/G
AT#SELINT? Read command reports the current interface style.
AT#SELINT=? Test command reports the available range of values for parameter <v>.
Note It’s suggested to reboot the module after every #SELINT setting.
3.5.2.1.2 Set Notification Port - #NOPT
#NOPT - Set notification port
AT#NOPT=<num> Set command sets the port output notification data (Indication data)
UC864 Family has the following 5 ports:
• Telit USB Modem Port
• Telit USB Diagnostic Interface Port
• Telit USB Auxiliary Port
• UART Data Port
• UART Trace Port
Notification data will be sent to the specific port is set by #NOPT.
Each port has the capability like as below table
GND
(C102)
TD
(C103)
RD
(C104)
RTS
(C105)
CTS
(C106)
DSR
(C107)
DTR
(C108)
RI
(C125)
DCD
(C125)
USB
Modem
USB
Diagnosti
c
USB
Auxiliary
UART
DATA
UART
TRACE
USB Diagnostic and UART TRACE are reserved for Telit Service.
USB Modem,USB Auxiliary and UART DATA are dedicated for M2M