Specifications

UC864-E/G AT Commands Reference Guide
80304ST10041a Rev. 3 - 18/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 248 of 259
#STIA - SIM Tookit Interface Activation
Note: In SAT applications usually an SMS message is sent to the network
provider containing service requests, e.g. to send the latest news. The
provider returns a message with the requested information.
Before activating SAT it is recommended to set the SMS text mode with
command AT+CMGF=1 and to enable unsolicited indications for incoming
SMS messages with command +CNMI.
AT#STIA=? Test command returns the range of available values for the parameters
<mode> and <timeout>.
Note Just one instance at a time, the one which first issued AT#STIA=n (with n
different from zero), is allowed to issue SAT commands, and this is valid till
the same instance issues AT#STIA=0.
After power cycle another instance can enable SAT.
Note A typical SAT session on AT interface starts after an #STN: 37 unsolicited
code is received, if enabled(see above). At that point usually an
AT#STSG=37 command is issued (see #STSGI) and after the SAT main
menu has been displayed on TE an AT#STSR=37,0,x command is issued
to select an item in the menu (see #STSR)
3.5.7.8.2 SIM Tookit Get Information - #STGI
#STGI - SIM Tookit Get Information
AT#STGI=
[<cmdType>]
#STGI set command is used to request the parameters of a proactive
command from the ME.
Parameter:
<cmdType> - proactive command ID according to 3GPP TS 31.114
(decimal); these are only those command types that use the AT
interface; SAT commands which are not using the AT interface
(not MMI related SAT commands, e.g. PROVIDE LOCAL
INFORMATION) are executed without sending any indication to
the user
1 - REFRESH
16 - SET UP CALL
17 - SEND SS
18 - SEND USSD
19 - SEND SHORT MESSAGE
20 - SEND DTMF
32 - PLAY TONE
33 - DISPLAY TEXT
34 - GET INKEY
35 - GET INPUT
36 - SELECT ITEM