Specifications

UC864-E/G AT Commands Reference Guide

80304ST10041a Rev. 3 - 18/07/08

#STIA - SIM Tookit Interface Activation

centre address or destination has been changed:

#STN: <cmdTerminateValue>,<Result>[,<TextInfo>[,<Number>

[,<MODestAddr>]]]

where

150 - SMS control response

160 - call/SS/USSD response

0 - Call/SMS not allowed

1 - Call/SMS allowed

2 - Call/SMS allowed with modification

<Number> - Called number, Service Center Address or SS String in ASCII

format.

<MODestAddr> - MO destination address in ASCII format.

<TextInfo> - alpha identifier provided by the SIM in ASCII format.

Note: when the SIM Application enters its main menu again (i.e. not at

startup) an unsolicited result code

#STN: 254

is sent.

The TA does not need to respond directly, i.e. AT#STSR is not required.

It is possible to restart the SAT session from the main menu again with the

command AT#STGI=37.

Note: The settings are saved on user profile and available on following

reboot. SIM Toolkit activation/deactivation is only performed at power on.

AT#STIA? Read command can be used to get information about the SAT interface in

the format:

#STIA: <state>,<mode>,<timeout>,<SatProfile>

where:

<state> - the device is in one of the following state:

0 - SIM has not started its application yet

1 - SIM has started its application (SAT main menu ready)

<mode> - SAT and unsolicited indications enabling status (see above)

<timeout> - time-out for user responses (see above)

<SatProfile> - SAT Terminal Profile according to 3GPP TS 31.114, i. e. the

list of SIM Application Toolkit facilities that are supported by

the ME. The profile cannot be changed by the TA.