Specifications

UC864-E/G AT Commands Reference Guide
80304ST10041a Rev. 3 - 18/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 243 of 259
3.5.7.7.6 Wake Up GPS From Power Saving Mode - $GPSWK
$GPSWK - Wake Up GPS From Power Saving Mode
AT$GPSWK Execution command allows to wake up the GPS module if set in sleeping
mode due to power saving.
Note: if the GPS module is in push-to-fix mode, issuing $GPSWK pemits to
wake up it before the push to fix period; after the new fix the GPS module
will return in push-to-fix mode with the same parameters.
AT$GPSWK=? Test command returns the OK result code
Note Available in “controlled mode” only
3.5.7.7.7 Save GPS Parameters Configuration - $GPSSAV
$GPSSAV - Save GPS Parameters Configuration
AT$GPSSAV Execution command stores the current GPS parameters in the NVM of the
device.
AT$GPSSAV=? Test command returns the OK result code
Example AT$GPSSAV
OK
Note The module must be restarted to use the new configuration
3.5.7.7.8 Restore To Default GPS Parameters - $GPSRST
$GPSRST - Restore To Default GPS Parameters
AT$GPSRST Execution command resets the GPS parameters to “Factory Default”
configuration and stores them in the NVM of the device.
AT$GPSRST=? Test command returns the OK result code
Example AT$GPSRST
OK
Note The module must be restarted to use the new configuration