Specifications

UC864-E/G AT Commands Reference Guide
80304ST10041a Rev. 3 - 18/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 218 of 259
#SKTL - Socket Listen
Now listen is not anymore active
to stop listening
AT#SKTL=0,0,1024, 255
OK
Note The main difference between this command and #SKTD is that #SKTL
does not contact any peer, nor does any interaction with the GPRS context
status, leaving it ON or OFF according to the #GPRS setting, therefore
when the connection made with #SKTL is closed the context (and hence
the local IP address) is maintained.
3.5.7.4.15 Socket Listen Ring Indicator - #E2SLRI
#E2SLRI - Socket Listen Ring Indicator
AT#E2SLRI=[<n>] Set command enables/disables the Ring Indicator pin response to a Socket
Listen connect and, if enabled, the duration of the negative going pulse
generated on receipt of connect.
Parameter:
<n> - RI enabling
0 - RI disabled for Socket Listen connect (factory default)
50..1150 - RI enabled for Socket Listen connect; a negative going pulse is
generated on receipt of connect and <n> is the duration in ms of this pulse.
AT#E2SLRI? Read command reports whether the Ring Indicator pin response to a Socket
Listen connect is currently enabled or not, in the format:
#E2SLRI: <n>
AT#E2SLRI=? Test command returns the allowed values for parameter <status>.
3.5.7.4.16 Firewall Setup - #FRWL
#FRWL - Firewall Setup
AT#FRWL=
[<action>,
<ip_address>,
<net mask>]
Execution command controls the internal firewall settings.
Parameters:
<action> - command action
0 - remove selected chain
1 - add an ACCEPT chain
2 - remove all chains (DROP everything); <ip_addr> and <net_mask>
has no meaning in this case.
<ip_addr> - remote address to be added into the ACCEPT chain; string
type, it can be any valid IP address in the format:
xxx.xxx.xxx.xxx
<net_mask> - mask to be applied on the <ip_addr>; string type, it can be
any valid IP address mask in the format: xxx.xxx.xxx.xxx