Specifications

UC864-E/G AT Commands Reference Guide

80304ST10041a Rev. 3 - 18/07/08

<interval> - duration in seconds of the interval between two consecutive

antenna detection algorithm runs (default is 120). It has

meaning only if <mod> is 1.

1..3600 - seconds

<detGPIO> - defines which GPIO shall be used as input by the Antenna

Detection algorithm (default 13)..

Valid range is “any input pin number” (see “Hardware User Guide”).

<repGPIO> - defines which GPIO shall be used by the Antenna Detection

algorithm to report antenna condition. Value 0 means that no

report is made using GPIO (default 0). It has meaning only if

<mod> is 1.

0 - no report is made using GPIO

Valid range is “any output pin number” (see “Hardware User Guide”).

Note: last <urcmode> settings are saved as extended profile parameters.

Note: GPIO is set to LOW when antenna is connected. Set to HIGH

otherwise

Note: #GSMAD parameters, excluding <urcmode>, are saved in NVM.

AT#GSMAD=?

Test command reports the supported range of values for parameters

<mod>, <urcmode>, <interval>, <detGPIO> and <repGPIO>.

AT#GSMAD? Read command returns the current parameter settings for #GSMAD

command in the format:

#GSMAD: <mod>,<urcmode>,<interval>,<detGPIO>,<repGPIO>