Specifications

UC864-E/G AT Commands Reference Guide
80304ST10041a Rev. 3 - 18/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 195 of 259
3.5.7.1.67 Escape Sequence Guard Time - #E2ESC
#E2ESC - Escape Sequence Guard Time
AT#E2ESC=
[<gt>]
Set command sets a guard time in seconds for the escape sequence in
GPRS to be considered a valid one (and return to on-line command mode).
Parameter:
<gt>
0 - no guard time (factory default)
1..10 - guard time in seconds
Note: if the Escape Sequence Guard Time is set to a value different from
zero, it overrides the one set with S12.
AT#E2ESC? Read command returns current value of the escape sequence guard time,
in the format:
#E2ESC: <gt>
AT#E2ESC=? Test command returns the OK result code.
3.5.7.1.68 PPP-GPRS Connection Authentication Type - #GAUTH
#GAUTH - PPP-GPRS Connection Authentication Type
AT#GAUTH=
[<type>]
Set command sets the PPP-GPRS connection authentication type.
Parameter
<type>
3 – AUTO authentication (PAP and CHAP , factory default)
Note: for PPP passive mode , <type> is fixed to AUTO.
AT#GAUTH? Read command reports the current PPP-GPRS connection authentication
type, in the format:
#GAUTH: <type>
AT#GAUTH=? Test command returns the range of supported values for parameter
<type>.
3.5.7.1.69 RTC Status - #RTCSTAT
#RTCSTAT - RTC Status
AT#RTCSTAT=
[<status>]
Set command resets the RTC status flag.
Parameter:
<status>
0 - Set RTC Status to RTC HW OK