Specifications

UC864-E/G AT Commands Reference Guide

80304ST10041a Rev. 3 - 18/07/08

#AUTOBND - Automatic Band Selection

AT#AUTOBND=

[<value>]

Set command enables/disables the automatic band selection at power-on.

Parameter:

<value>:

0 - disables automatic band selection at power-on (factory default)

1 - enables automatic band selection at power-on; +COPS=0 is necessary

condition to effectively have automatic band selection at next power-on;

the automatic band selection stops as soon as a GSM cell is found.

Note: if automatic band selection is enabled the band changes every about

90 seconds through available bands until a GSM cell is found.

AT#AUTOBND? Read command returns whether the automatic band selection is enabled or

not in the form:

#AUTOBND: <value>

AT#AUTOBND=? Test command returns the range of supported values for parameter

<value>.

3.5.7.1.66 Skip Escape Sequence - #SKIPESC

#SKIPESC - Skip Escape Sequence

AT#SKIPESC=

[<mode>]

Set command enables/disables skipping the escape sequence +++ while

transmitting during a data connection.

Parameter:

<mode>

0 - doesn’t skip the escape sequence; its transmission is enabled (factory

default).

1 - skips the escape sequence; its transmission is not enabled.

Note: in case of an FTP connection, the escape sequence is not

transmitted, regardless of the command setting.

AT#SKIPESC? Read command reports whether escape sequence skipping is currently

enabled or not, in the format:

#SKIPESC: <mode>

AT#SKIPESC=? Test command reports supported range of values for parameter <mode>.