Specifications

UC864-E/G AT Commands Reference Guide
80304ST10041a Rev. 3 - 18/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 191 of 259
#SHSEC - Handset Echo Canceller
0 - disables echo canceller for handset mode (default)
1 - enables echo canceller for handset mode
Note: This parameter is saved in NVM issuing AT&W command.
AT#SHSEC? Read command reports whether the echo canceller function on audio
handset output is currently enabled or not, in the format:
#SHSEC: <mode>
AT#SHSEC =? Test command returns the supported range of values of parameter
<mode>.
3.5.7.1.60 Handset Noise Reduction - #SHSNR
#SHSNR - Handset Noise Reduction
AT# SHSNR =
<mode>
Set command enables/disables the noise reduction function on audio
handset input.
Parameter:
<mode>
0 - disables noise reduction for handset mode (default)
1 - enables noise reduction for handset mode
Note: This parameter is saved in NVM issuing AT&W command.
AT# SHSNR? Read command reports whether the noise reduction function on audio
handset input is currently enabled or not, in the format:
# SHSNR: <mode>
AT# SHSNR =? Test command returns the supported range of values of parameter
<mode>.
3.5.7.1.61 Set Handset Sidetone - #SHSSD
#SHSSD - Set Handset Sidetone
AT#SHSSD=
<mode>
Set command enables/disables the sidetone on handset audio output.
Parameter:
<mode>
0 - disables the handset sidetone
1 - enables the handset sidetone (factory default)
Note: This parameter is saved in NVM issuing AT&W command.
AT#SHSSD?
Read command reports whether the headset sidetone is currently enabled
or not, in the format: