Specifications

UC864-E/G AT Commands Reference Guide
80304ST10041a Rev. 3 - 18/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 179 of 259
3.5.7.1.38 Automatic Call - #ACAL
#ACAL - Automatic Call
AT#ACAL=
[<mode>]
Set command enables/disables the automatic call function.
Parameter:
<mode>
0 - disables the automatic call function (factory default)
1 - enables the automatic call function. If enabled (and &D2 has been
issued), the transition OFF/ON of DTR causes an automatic call to the
first number (position 0) stored in the internal phonebook.
Note: type of call depends on the last issue of command +FCLASS .
AT#ACAL? Read command reports whether the automatic call function is currently
enabled or not, in the format:
#ACAL: <mode>
where
<mode>
0 - automatic call function disabled
1 - automatic call function from internal phonebook enabled
2 - automatic call function from “SM” phonebook enabled (by
AT#ACALEXT)
3 - automatic call function from “ME” phonebook enabled (by
AT#ACALEXT)
AT#ACAL=? Test command returns the supported range of values for parameter
<mode>.
Note See &Z to write and &N to read the number on module internal phonebook.
3.5.7.1.39 Extended Automatic Call - #ACALEXT
#ACALEXT - Extended Automatic Call
AT#ACALEXT=
<mode>,<index>
Set command enables/disables the extended automatic call function.
Parameters:
<mode>
0 - disables the automatic call function (factory default)
1 - enables the automatic call function from internal phonebook.
2 - enables the automatic call function from “SM” phonebook.
3 - enables the automatic call function from “ME” phonebook.
<index> - it indicates a position in the currently selected phonebook.
If the extended automatic call function is enabled and &D2 has been issued,
the transition OFF/ON of DTR causes an automatic call to the number
stored in position <index> in the selected phonebook.