Specifications

UC864-E/G AT Commands Reference Guide
80304ST10041a Rev. 3 - 18/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 178 of 259
#QSS - Query SIM Status
3 - SIM INSERTED and READY (SMS and Phonebook access are
possible).
Note: issuing AT#QSS<CR> is the same as issuing the Read command.
Note: issuing AT#QSS=<CR> is the same as issuing the command
AT#QSS=0<CR>.
AT#QSS? Read command reports whether the unsolicited indication #QSS is currently
enabled or not, along with the SIM status, in the format:
#QSS: <mode>,<status>
(<mode> and <status> are described above)
AT#QSS=? Test command returns the supported range of values for parameter
<mode>.
Example
AT#QSS?
#QSS:0,1
OK
3.5.7.1.37 Dialling Mode - #DIALMODE
#DIALMODE - Dialling Mode
AT#DIALMODE=
[<mode>]
Set command sets dialling modality.
Parameter:
<mode>
0 - (voice call only) OK result code is received as soon as it starts remotely
ringing (factory default)
1 - (voice call only) OK result code is received only after the called party
answers. Any character typed aborts the call and OK result code is
received.
2 - (voice call and data call) the following custom result codes are
received, monitoring step by step the call status:
DIALING (MO in progress)
RINGING (remote ring)
CONNECTED (remote call accepted)
RELEASED (after ATH)
DISCONNECTED (remote hang-up)
Note: The setting is saved in NVM and available on following reboot.
AT#DIALMODE? Read command returns current ATD dialing mode in the format:
#DIALMODE: <mode>
AT#DIALMODE=? Test command returns the range of values for parameter <mode>