Specifications

UC864-E/G AT Commands Reference Guide
80304ST10041a Rev. 3 - 18/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 175 of 259
#MONI - Cell Monitor
(WCDMA network)
#MONI: <netmame> PSC:<psc> RSCP:<rscp> LAC:<lac>
EcIo:<ecio> UARFCN:<uarfcn> PWR:<dBm> dBm DRX:<drx>
b) When the network name is unknown, the format is:
(GSM network)
#MONI: Cc:<cc> Nc:<nc> BSIC:<bsic> RxQual:<qual> LAC:<lac>
Id:<id> ARFCN:<arfcn> PWR:<dBm> dBm TA: <timadv>
(WCDMA network)
#MONI: Cc:<cc> Nc:<nc> PSC:<psc> RSCP:<rscp> LAC:,<lac>
EcIo:<ecio> UARFCN:<uarfcn> PWR:<dBm> dBm DRX:<drx>
c) When extracting data for an adjacent cell, the format is:
(GSM network)
#MONI: Adj Cell<n> [LAC:<lac> Id:<id>] ARFCN:<arfcn>
PWR:<dBm> dBm
(WCDMA network)
#MONI: <adj cell> PSC:<psc> RSCP:<rscp> EcIo:<ecio>
UARFCN:<uarfcn>
where:
<netname> - name of network operator
<cc> - country code
<nc> - network operator code
<n> - progressive number of adjacent cell
<bsic> - base station identification code
<qual> - quality of reception
0..7
<lac> - localization area code
<id> - cell identifier
<arfcn> - assigned radio channel
<dBm> - received signal strength in dBm
<timadv> = timing advance
<psc> - primary synchronisation code
<rscp> - Received Signal Code Power in dBm
<ecio> - chip energy per total wideband power in dBm
<uarfcn> - UMTS assigned radio channel
<drx> - Discontinuous reception cycle length
Note: TA: <timadv> is reported only for the serving cell.
When the last setting done is AT#MONI=7, then the Read command reports
the above informations for each of the cells in the neighbour of the serving
cell, formatting them in a sequence of <CR><LF>-terminated strings.
Currently, it is available in case of GSM network.
AT#MONI=? Test command reports the maximum number of cells, in a neighbour of the
serving cell excluding it, from which we can extract GSM/WCDMA-related