Specifications

UC864-E/G AT Commands Reference Guide
80304ST10041a Rev. 3 - 18/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 169 of 259
#E2SMSRI - SMS Ring Indicator
AT#E2SMSRI? Read command reports the duration in ms of the pulse generated on
receipt of an incoming SM, in the format:
#E2SMSRI: <n>
Note: as seen before, the value <n>=0 means that the RI pin response to
an incoming SM is disabled.
AT#E2SMSRI=? Reports the range of supported values for parameter <n>
Example
AT#E2SMSRI=50
OK
3.5.7.1.24 Read Analog/Digital Converter Input - #ADC
#ADC - Read Analog/Digital Converter Input
AT#ADC=
[<adc>,<mode>
[,<dir>]]
Execution command reads pin<adc> voltage, converted by ADC, and
outputs it in the format:
#ADC: <value>
where:
<value> - pin<adc> voltage, expressed in mV
Parameters:
<adc> - index of pin
1 - available for UC864-E, UC864-G and UC864-E-AUTO
2 - available only for UC864-E, UC864-G and UC864-E-AUTO
3 - available only for UC864-E, UC864-G and UC864-E-AUTO
<mode> - required action
2 - query ADC value
<dir> - direction; its interpretation is currently not implemented
0 - no effect.
Note: The command returns the last valid measure.
AT#ADC? Read command reports all pins voltage, converted by ADC, in the format:
#ADC: <value>[<CR><LF>#ADC: <value>[…]]
AT#ADC=? Test command reports the supported range of values of the command
parameters <adc>, <mode> and <dir>.
3.5.7.1.25 Digital/Analog Converter Control - #DAC
#DAC - Digital/Analog Converter Control
AT#DAC=
[<enable>
[,<value>]]
Set command enables/disables the DAC_OUT pin.
Parameters: