Specifications

UC864-E/G AT Commands Reference Guide
80304ST10041a Rev. 3 - 18/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 162 of 259
#SHDN - Software Shutdown
Note: to turn it on again Hardware pin ON/OFF must be tied low.
Note: to turn it off, USB_VBUS pin must be tied low.
AT#SHDN=? Test command returns the OK result code.
3.5.7.1.16 Wake From Alarm Mode - #WAKE
#WAKE - Wake From Alarm Mode
AT#WAKE=
[<opmode>]
Execution command stops any eventually present alarm activity and, if the
module is in alarm mode, it exits the alarm mode and enters the normal
operating mode.
Parameter:
<opmode> - operating mode
0 - normal operating mode; the module exits the alarm mode, enters the
normal operating mode, any alarm activity is stopped (e.g. alarm tone
playing) and an OK result code is returned.
Note: The "alarm mode" is indicated by hardware pin CTS to the ON status
and DSR to the OFF status, while the "power saving" status is indicated by
a CTS - OFF ,DSR - OFF and USB_VBUS – OFF status. The normal
operating status is indicated by DSR – ON or USB_VBUS – ON status.
Note: during the alarm mode the device will not make any network scan
and will not register to any network and therefore is not able to dial or
receive any call or SM, the only commands that can be issued to the
MODULE in this state are the #WAKE and #SHDN, every other command
must not be issued during this state.
AT#WAKE? Read command returns the operating status of the device in the format:
#WAKE: <status>
where:
<status>
0 - normal operating mode
1 - alarm mode or normal operating mode with some alarm activity.
3.5.7.1.17 Query Temperature Overflow - #QTEMP
#QTEMP - Query Temperature Overflow
AT#QTEMP=
[<mode>]
Set command has currently no effect. The interpretation of parameter
<mode> is currently not implemented: any value assigned to it will simply
have no effect.