Specifications

UC864-E/G AT Commands Reference Guide
80304ST10041a Rev. 3 - 18/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 159 of 259
#SRS - Select Ringer Sound
<n> - ringing tone
0 - current ringing tone
1..max - ringing tone number, where max can be read by issuing the Test
command AT#SRS=?.
<tout> - ringing tone playing time-out in seconds.
0 - ringer is stopped (if present) and current ringer sound is set.
1..60 - ringer sound playing for <tout> seconds and, if <n> > 0, ringer
sound <n> is set as default ringer sound.
Note: when the command is issued with <n> > 0 and <tout> > 0, the <n>
ringing tone is played for <tout> seconds and stored as default ringing tone.
Note: if command is issued with <n> > 0 and <tout> = 0, the playing of the
ringing is stopped (if present) and <n> ringing tone is set as current.
Note: if command is issued with <n> = 0 and <tout> > 0 then the current
ringing tone is played.
Note: if both <n> and <tout> are 0 then the default ringing tone is set as
current and ringing is stopped.
Note: If all parameters are omitted then the behaviour of Set command is
the same as Read command
AT#SRS? Read command reports current selected ringing and its status in the form:
#SRS: <n>,<status>
where:
<n> - ringing tone number
1..max
<status> - ringing status
0 - selected but not playing
1 - currently playing
AT#SRS=? Test command reports the supported values for the parameters <n> and
<tout>
3.5.7.1.11 Select Ringer Path - #SRP
#SRP - Select Ringer Path
AT#SRP=[<n>] Set command selects the ringer path towards whom sending ringer sounds
and all signalling tones.
Parameter:
<n> - ringer path number
0 - sound output towards current selected audio path (see
command #CAP)
1 - sound output towards handsfree