Specifications

UC864-E/G AT Commands Reference Guide
80304ST10041a Rev. 3 - 18/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 155 of 259
+FCL - Carrier loss timeout
AT+FCL=[<time>] Execution command sets carrier loss timeout
Parameter:
< time >
0 - 255
Note: The FCL parameter allows the DTE to select the DCE’s loss-of-carrier
delay between initial loss-of-carrier and qualified loss-of-carrier, when the
DCE will give up and exit a receive mode.
AT+FCL? Read command reports the current value of the parameter.
AT+FCL=? Test command returns all supported values of the parameter.
Reference ITU T.31 and TIA/EIA-578-A specifications