Specifications

UC864-E/G AT Commands Reference Guide

80304ST10041a Rev. 3 - 18/07/08

3.5.6.2 Transmission/Reception Control

3.5.6.2.1 Stop Transmission And Pause - +FTS

+FTS - Stop Transmission And Pause

AT+FTS=<time> Execution command causes the modem to terminate a transmission and

wait for <time> 10ms intervals before responding with OK result.

Parameter:

<time> - duration of the pause, expressed in 10ms intervals.

0..255

AT+FTS=? Test command returns all supported values of the parameter <time>.

Note: test command result is without command echo

Reference ITU T.31 and TIA/EIA-578-A specifications

3.5.6.2.2 Wait For Receive Silence - +FRS

+FRS - Wait For Receive Silence

AT+FRS=<time> Execution command causes the modem to listen and report OK when

silence has been detected for the specified period of time.

This command will terminate when the required silence period is detected or

when the DTE sends another character other than XON or XOFF.

Parameter:

<time> - amount of time, expressed in 10ms intervals.

..0..255

AT+FRS=? Test command returns all supported values of the parameter <time>.

Note: test command result is without command echo

Reference ITU T.31 and TIA/EIA-578-A specifications

3.5.6.2.3 Transmit Data Modulation - +FTM

+FTM - Transmit Data

AT+FTM=<mod> Execution command causes the module to transmit facsimile data using the

modulation defined by the parameter <mod>.

Parameter:

<mod> - carrier modulation

72 - V29/7200 bps

73 - V17/7200 bps Training Long

74 - V17/7200 bps Training Short

96 - V29/9600 bps