Specifications

UC864-E/G AT Commands Reference Guide
80304ST10041a Rev. 3 - 18/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 133 of 259
+CNMI - New Message Indications To Terminal Equipment
given before flushing the codes)
1 - TA buffer of unsolicited result codes defined within this command is
cleared when <mode>=1..3 is entered.
AT+CNMI? Read command returns the current parameter settings for +CNMI command
in the form:
+CNMI: <mode>,<mt>,<bm>,<ds>,<bfr>
AT+CNMI=? Test command reports the supported range of values for the +CNMI
command parameters.
Reference 3GPP TS 27.005
Example
AT+CMGF=1
OK
AT+CNMI=1,2,0,1,0
OK
Received message from network
+CMT: "[phone]",,"07/07/26,20:09:07+36"
TEST MESSAGE
Note DTR signal is ignored, hence the indication is sent even if the DTE is
inactive ( DTR signal is Low). In this case the unsolicited result code may
be lost so if MODULE remains active while DTE is not, at DTE startup is
suggested to check whether new messages have reached the device
meanwhile with command AT+CMGL=0 that lists the new messages
received.
3.5.5.3.2 List Messages - +CMGL
+CMGL - List Messages
AT+CMGL
[=<stat>]
Execution command reports the list of all the messages with status value
<stat> stored into <memr> message storage (<memr> is the message
storage for read and delete SMs as last settings of command +CPMS).
The parameter type and the command output depend on the last settings of
command +CMGF (message format to be used)
(PDU Mode)
Parameter:
<stat>
0 - new message
1 - read message
2 - stored message not yet sent
3 - stored message already sent
4 - all messages.
Each message to be listed is represented in the format: