Specifications

UC864-E/G AT Commands Reference Guide
80304ST10041a Rev. 3 - 18/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 132 of 259
+CNMI - New Message Indications To Terminal Equipment
+CBM:<sn>,<mid>,<dcs>,<pag>,<pags><CR><LF><data>
where:
<sn> - message serial number
<mid> - message ID
<dcs> - Data Coding Scheme
<pag> - page number
<pags> - total number of pages of the message
<data> - CBM Content of Message
• If <dcs> indicates that GSM03.38/23.038 default alphabet is
used , each character of GSM/WCDMA alphabet will be
converted into current TE character set (see +CSCS)
• If <dcs> indicates that 8-bit or UCS2 data coding scheme is
used, each 8-bit octet will be converted into two IRA character
long hexadecimal number (e.g. octet 0x2A will be converted as
two characters 0x32 0x41)
<ds> - SMS-STATUS-REPORTs reporting option
0 - status report receiving is not reported to the DTE
1 - the status report is sent to the DTE with the following unsolicited result
code:
(PDU Mode)
+CDS: <length><CR><LF><PDU>
where:
<length> - PDU length
<PDU> - message PDU
(TEXT Mode)
+CDS: <fo>,<mr>,,,<scts>,<dt>,<st>
where:
<fo> - first octet of the message PDU
<mr> - message reference number
<scts> - arrival time of the message to the SC
<dt> - sending time of the message
<st> - message status as coded in the PDU
2 - if a status report is stored, then the following unsolicited result code is
sent:
+CDSI: <memr>,<index>
where:
<memr> - memory storage where the new message is stored
"SR"
<index> - location on the memory where SMS is stored
<bfr> - buffered result codes handling method:
0 - TA buffer of unsolicited result codes defined within this command is
flushed to the TE when <mode>=1..3 is entered (OK response shall be