Specifications

UC864-E/G AT Commands Reference Guide
80304ST10041a Rev. 3 - 18/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 119 of 259
+CGPADDR - Show PDP Address
<PDP_addr>[…]]
Parameters:
<cid> - a numeric parameter which specifies a particular PDP context
definition (see +CGDCONT command). If no <cid> is specified, the
addresses for all defined contexts are returned.
<PDP_addr> - a string that identifies the terminal in the address space
applicable to the PDP. The address may be static or
dynamic. For a static address, it will be the one set by the
+CGDCONT command when the context was defined. For a
dynamic address it will be the one assigned during the last
PDP context activation that used the context definition
referred to by <cid>; <PDP_addr> is omitted if none is
available
AT+CGPADDR=? Test command returns a list of defined <cid>s.
Example
AT#GPRS=1
+IP: xxx.yyy.zzz.www
OK
AT+CGPADDR=1
+CGPADDR: 1,”xxx.yyy.zzz.www”
OK
AT+CGPADDR=?
+CGPADDR: (1)
OK
Reference 3GPP TS 27.007
3.5.4.7.11 3G Quality of Service Profile (Negotiated) - +CGEQNEG
+CGEQNEG – 3G Quality Of Service Profile (Negotiated)
AT+CGEQNEG=
[<cid>[,<cid>[,…]]]
This command allow the TE to retrieve the negotiated 3G quality of service
profiles returned in the Activate PDP Context Accept message.
Set command returns the negotiated 3G QoS profile for the specified
context identifiers, <cid>s. The Qos profile consists of a number of
parameters, each of which may have a separate value.
Parameters:
<cid> - PDP context identification (see +CGDCONT command).
AT+CGEQNEG=? Test command returns a list of <cid>s associated with active contexts.
Example AT+CGEQREQ?
+CGEQREQ: 1,4,0,0,0,0,2,0,"0E0","0E0",3,0,0