Specifications

UC864-E/G AT Commands Reference Guide
80304ST10041a Rev. 3 - 18/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 118 of 259
+CGEQREQ – 3G Quality Of Service Profile (Requested)
16000),(0-2),(0-
1520),("0E0","1E1","1E2","7E3","1E3","1E4","1E5","1E6"),(
"0E0","5E2","1E2","5E3","4E3","1E3","1E4","1E5","1E6","6E
8"),(0-3),(0,100-4000),(0-3)
OK
Reference 3GPP TS 27.007; 3GPP TS 03.60/23.060; 3GPP TS 24.008
3.5.4.7.9 PDP Context Activate Or Deactivate - +CGACT
+CGACT - PDP Context Activate Or Deactivate
AT+CGACT=
[<state>[,<cid>
[,<cid>[,…]]]]
Execution command is used to activate or deactivate the specified PDP
context(s)
Parameters:
<state> - indicates the state of PDP context activation
0 - deactivated
1 - activated
<cid> - a numeric parameter which specifies a particular PDP context
definition (see +CGDCONT command)
Note: if no <cid>s are specified the activation/deactivation form of the
command activates/deactivates all defined contexts.
AT+CGACT? Read command returns the current activation state for all the defined PDP
contexts in the format:
+CGACT: <cid>,<state>[<CR><LF>+CGACT: <cid>,<state>[…]]
AT+CGACT=? Test command reports information on the supported PDP context activation
states parameters in the format:
+CGACT: (0,1)
Example
AT+CGACT=1,1
OK
AT+CGACT?
+CGACT: 1,1
OK
Reference 3GPP TS 27.007
3.5.4.7.10 Show PDP Address - +CGPADDR
+CGPADDR - Show PDP Address
AT+CGPADDR=
[<cid>[,<cid>
[,…]]]
Execution command returns a list of PDP addresses for the specified
context identifiers in the format:
+CGPADDR: <cid>,<PDP_addr>[<CR><LF>+CGPADDR: <cid>,